Du verwendest einen veralteten Browser. Es ist möglich, dass diese oder andere Websites nicht korrekt angezeigt werden. Du solltest ein Upgrade durchführen oder einen alternativen Browser verwenden.
News!!!
New clone Prodigy ER-16, modified classic MOOG PRODIGY:
Prodigy ER-16 EURO RACK 42HP
https://www.facebook.com/EnsureSound/
Technical specification same as MOOG PRODIGY...
Modification:
- dual CV for OSC1 and OSC2 (single and dual mode)
- noise generator (white, pink) with noise...
News!!!
New clone Prodigy ER-16, modified classic MOOG PRODIGY:
Prodigy ER-16 EURO RACK 42HP
https://www.facebook.com/EnsureSound/
Technical specification same as MOOG PRODIGY...
Modification:
- dual CV for OSC1 and OSC2
- noise generator (white, pink) with noise level control and output
-...
Hi!
Power to the MIDI controller you can take with the main board +12V and -12V.
I left the only stabilizer + 5V supply for MCU and DAC.
If you look at the circuit, I think it's all clear. :)
Regards,
Ensure Sound
@StormB
Great idea, to make the Prodigy in the classic case! :supi:
I look forward to completing the project, photos and samples!
Best regards,
EnsureSound
For all,
If you have any questions regarding the Moog Prodigy clone DIY.
Write to me in PM, which would not be confused.
Common themes I try to discuss here, and immediately informed of any observations.
I find it easier to quickly answer your question. Then there is no information chaos.
I'm...
For Protonstudio,
If your "pulse wave OSC1" is stable, then nothing changes.
This change is beneficial for the stable operation of the OSC1 pulse wave.
If there is a problem with "pulse wave OSC1" in this case is necessary to replace the resistors.
To avoid confusion further, check your...
I'm very happy for you! Finally all turned out! :phat: :phat: :phat:
What potentiometers is not correct?
There are errors in the wiring guide?
I have to check it out... :agent:
@Binaural
It applies only to those who have purchased, unpopulated PCB.
Your PCB has been carefully tested and calibrated before shipment.
Of course I can not rule that you need to adjust the "TUNE" of OSC 1 and 2.
After the final assembly...
Regards
Dmitry