Michael Burman schrieb:
@Rookie2:
Ich habe V2 (PC3: 27.05.2011, PC3K: 07.06.2011) in Englisch heruntergeladen, und da sind die Seiten und Controller-Nummern anders.
die haben die controller nummern tatsächlich geändert.
Nach der Liste finde ich die Attack Velocity auch nicht mehr.
bin noch bei 2.10 heißt dass, beim update auf 2.20 kann
der pc3 diese controller nicht mehr adressieren???
aus der anleitung 6-16
Alternative Controller (AltControl)
See Alternative Switch (AltControl and AltMethod) below.
Alternative Switch (AltControl and AltMethod)
Many, but not all, PC3K sample roots have been pre‐assigned a carefully chosen alternate
sample start point that can be selected using the Alternate Switch feature (AltControl and
AltMethod parameters). This feature allows you to control the sample playback start/end time
triggered by any control source. (The alternate sample start point can be adjusted by editing a
sample, see Editing Samples on page 14‐9 and The TRIM Page on page 14‐12 for details.)
Use the AltControl parameter to specify a control source that will cause the sample to begin or
end at the Alt point. Then use the AltMethod parameter to choose between switched and
continuous calculation of the Alt point. If the value of AltMethod is Switched, the PC3K will use
the Alt point when the relevant control source is at a value greater than 64 at Note Start. If
AltMethod is Continuous, the Alt point will vary depending on the value of the relevant control
source at Note Start.
As an example, suppose you’re working with a flute keymap and wish to control the amount of
chiff heard at the beginning of the sound. On the KEYMAP page in the Program Editor, set
AltControl to MWheel. Now the Mod Wheel controls how much of the initial sample attack is
used. If you set AltMethod to Switched and move the Mod Wheel at least half‐way up, at Note
Start the sample will begin at the pre‐set alternate start point (in this case, slightly past the initial
chiff). If you set the AltMethod to Continuous, the PC3K will interpolate the sample’s starting
point based on the position of the Mod Wheel. If the Mod Wheel is 75% of the way up at Note
Start. the sample will begin 75% of the way between normal and alternate start points.