Re:
Ed Solo schrieb:
Super Tips Jungs! Hat alles geklappt.
Wenn wir schon dabei sind nochmal ne ganzu andere Frage: Man liest ja überall, dass man durch herausnehmen der Batterien Radnon-Patterns erzeugen kann.
Ich hab mir deshalb zu der 303 gleich mal die passenden Batterien zugelegt (alles in Canada), aber meine 303 will damit nicht angehen. Sie geht nur im Netzbetrieb.
Meint Ihr ich hab vielleicht nicht die 100% korrekten Batterien?
Hallo,
ist zwar ein Uralt Thread, aber ich hatte mit meiner fast neuwertigen TB-303 auch das Problem, dass sie nicht mit Batterien funktionierte, obwohl im Batteriefach alles wie neu war! Folgender Post brachte mich auf die Lösung des Problems:
http://www.firstpr.com.au/rwi/dfish/303-mods/#3.6
3.6 - Batteries not connecting
Early TB-303s had a positive battery connector which was rather thin - too thin for modern batteries
whose positive terminal does not stick out very far. Later ones were pressed differently and
were a few mm more towards the positive end of the battery. Simply remove the old battery connector
and form (IBM Selectric service instructions use the term "form" instead of "bend") the edges
of the connector so the contact area sticks out a little more.
The negative spring connector can be a problem too – especially when it has been subject to
corrosion from leaking batteries. Remove it from the machine, wash any corrosive materials
and rust from it and file the end to expose fresh steel.
The wires to these connectors often fracture after several assembly-reassembly cycles,
because the wire is impregnated with solder. Simply trim back the wires and re-solder them.
Technologytransplant.com now sell a kit with replacement battery contacts
(very nicely made, including the negative contact spring) and a new battery compartment cover.
Ich habe also die Replacement-Batterie-Kontakte von Technologie Transplants eingelötet und siehe da die TB-303 funktioniert mit Batterien!!!!!
Es lag also tatsächlich daran, dass die modernen Batterie-Kontakte zu kurz waren.
Das Problem ist wohl eher bei den erst-produzierten TB-303s zu finden!
Vielleicht hilft das ja noch einem anderen user weiter!